Flashing a CM2 MTK (CM2 stands for Chinese Miracle 2, and MTK refers to MediaTek) device involves using the CM2 tool to write firmware or perform repairs on MediaTek-based phones. Here's a step-by-step guide on how to flash an MTK phone using the CM2 tool:

Prerequisites:

1. CM2 Tool: You will need the Chinese Miracle 2 (CM2) software installed on your computer. You can download it from trusted sources.
2. MTK USB Drivers: Ensure you have the correct MediaTek USB drivers installed on your PC. This allows your computer to recognize your phone when in download mode.
3. Firmware: You need the correct stock firmware or custom firmware for your MTK device. This could be a .bin, .scatter, or other supported format.
4. USB Cable: A working USB cable to connect your device to the computer.
5. Backup: Always back up your data before flashing, as this process may erase all content on the device.

Steps to Flash MTK Device Using CM2:

Step 1: Install CM2 Tool and Drivers

• Install CM2: If you haven't already, download and install CM2 on your PC. Make sure to install it correctly following the instructions provided by the tool’s documentation.
• Install MediaTek USB Drivers: Ensure that your computer can detect the phone in download mode. This is crucial for flashing.
• Run CM2 Tool: Open the CM2 MTK tool on your computer.

Step 2: Prepare Firmware

• Get the correct firmware for your device (in a .scatter or .bin format). Make sure it is compatible with your phone model.

Step 3: Set Up the Flashing Process

1. Launch CM2 Tool: Run the CM2 tool on your computer.
2. Select MTK Tab: In CM2, select the MTK tab to work with MediaTek devices.
3. Choose Firmware: Load the firmware by selecting the .scatter file (if using a scatter file format). To do this, click the “Select Scatter” button and browse for the firmware folder where the scatter file is located.
4. Check Options: If you need to select specific partitions (e.g., only flashing system or boot), make sure to configure those in CM2 before proceeding.

Step 4: Connect Your Phone to the PC

1. Power Off Your Device: Turn off your MediaTek device completely.
2. Enter Download Mode: Press and hold the Volume Down or Volume Up button (or both, depending on the device) while connecting the device to the computer with a USB cable.
   • Some devices may require Preloader to be triggered before flashing, while others will automatically enter download mode when connected in a powered-off state.
3. CM2 Detects Device: Once your phone is connected and in download mode, CM2 should automatically detect your device. If it doesn't, make sure the USB drivers are properly installed.

Step 5: Start Flashing

• In CM2, after detecting your device, click the “Start” or “Flash” button to begin the flashing process.
• Wait for the tool to complete the flash process. It will show progress on the screen.

Step 6: Wait for Completion

• Once the flashing process is done, the tool will notify you that the operation is complete.
• Disconnect the Device: After flashing, disconnect the phone from the PC.

Step 7: Reboot Your Phone

• Your phone should now automatically boot up with the newly flashed firmware. If not, you can manually turn it on.

Troubleshooting:

• Device Not Detected: Ensure the correct MTK drivers are installed and the phone is properly in download mode.
• Flashing Failures: Try a different USB port or cable, or ensure the firmware matches your device's exact model.
• Boot Issues: If the phone is stuck in a boot loop, try performing a factory reset or re-flashing.

Download